+  1 Introduction
 +  2 Start a Power Supply Design
 +  3 Component Finder
 +  4 Project Management
 +  5 Loss Analysis
 +  6 Waveform Analysis
 +  7 Monte Carlo Analysis
 +  8 Loop Analysis
 +  9 Thermal Analysis
 +  10 Life & MTBF Analysis
 +  11 BOM - BOM Builder
 +  12 DVT Reports
 +  13 Magnetic Builder
 +  14 Add Parts
 +  15 Report Builder
 +  16 Harmonic
 +  17 EMI Analysis
 +  18 Component Builder
 +  19 Smart Optimizer
 +  20 General Function in PowerEsim
      21 Troubleshooting
 +  22 PowerEsim Account Management
      23 PowerEsim Terms of use
 +  24 User Interface Practice
Better Than Real - Free Switch Mode Power Supply Circuit (SMPS) Design Software & Transformer Calculation / Simulation Tool.
PowerEsim User Manual
PowerEsim is a free web-based software providing power supply (SMPS) design, transformer design, magnetic design, loss analysis, thermal analysis, waveform analysis, MTBF analysis, BOM building, DVT analysis and optimization of power supply (SMPS). Click to try PowerEsim (www.powerEsim.com)




7.5 Introduction to Interface (with topology) Back to top
  1. Top Bar
  2. No. of Sample
  3. No. of variating components
  4. Monte Carlo Analysis Result
  5. List of enabled Monte Carlo Analysis components
  6. Component List of all components in design


7.5.1 Top Bar Back to top
Please refer to Session 9.3.7--Top bar.

7.5.2 No. of Sample Back to top
Users can modify the number of sample in the position as shown below.


7.5.3 No. of variating component Back to top
No. of variating component means the number of components which had been enabled for Monte Carlo Analysis.


7.5.4 Monte Carlo Analysis Result Back to top
The result of the Monte Carlo Analysis is shown in this area.
Resulting loss/Vo values are divided by the number of bin to construct corresponding histograms.

Users can change the number of bin. The result will be recalculated after clicking [Recalculate] at the top right corner of the top bar.

7.5.5 List of enabled Monte Carlo Analysis components Back to top
In this list, users can modify the details of the Monte Carlo Analysis of the component.

1 . Click the blue button with the designator to enter the Component Finder page. For more details, please refer to Session 3--Component Finder.

2. In the Detail column, it shows the details of the Monte Carlo Analysis of the component. Users can modify these and then click [Recalculate] to update the result.

3. To disable a component from Monte Carlo Analysis, uncheck the box on the right, then click [Apply] to update the result.


7.5.6 Component List of all components in design Back to top
Click the blue button with the designator to enter the Component Finder page. For more details, please refer to Session 3--Component Finder.

To enable a component for Monte Carlo Analysis, check the box on the right, then click [Apply] to update result.



Home | Download | Useful Link | Video Demo | About | Contact Us | Disclaimer | FAQ Statistics | Account Management | Options | Preferences | Help | Table of Content