+  1 Introduction
 +  2 Start a Power Supply Design
 +  3 Component Finder
 +  4 Project Management
 +  5 Loss Analysis
 +  6 Waveform Analysis
 +  7 Monte Carlo Analysis
 +  8 Loop Analysis
 +  9 Thermal Analysis
 +  10 Life & MTBF Analysis
 +  11 BOM - BOM Builder
 +  12 DVT Reports
 +  13 Magnetic Builder
 +  14 Add Parts
 +  15 Report Builder
 +  16 Harmonic
 +  17 EMI Analysis
 +  18 Component Builder
 +  19 Smart Optimizer
 +  20 General Function in PowerEsim
      21 Troubleshooting
 +  22 PowerEsim Account Management
      23 PowerEsim Terms of use
 +  24 User Interface Practice
Better Than Real - Free Switch Mode Power Supply Circuit (SMPS) Design Software & Transformer Calculation / Simulation Tool.
PowerEsim User Manual
PowerEsim is a free web-based software providing power supply (SMPS) design, transformer design, magnetic design, loss analysis, thermal analysis, waveform analysis, MTBF analysis, BOM building, DVT analysis and optimization of power supply (SMPS). Click to try PowerEsim (www.powerEsim.com)




12.5.3.3.1 Component Setting Back to top
Click [setting] in the Component List to enter the component setting page.

The component designator is shown at the top left corner of the Component Setting page.

  1. Component Value Setting
  2. MTBF Factor
  3. Air Flow


12.5.3.3.1.1 Component Value Setting Back to top
To enable the gray input box for inputting a new value, check the [Yes] box and then input the new value.

Click the check box at the bottom to enable Optimization and Monte Carlo Analysis.


12.5.3.3.1.2 MTBF Factor Back to top
Users can change the setting for MTBF Analysis.


12.5.3.3.1.3 Air Flow Back to top
Users can modify the air flow for all sides.

Enable [Apply to ALL components] to change the air flow settings of all components with this set of values.

Click [Apply to All sides] to change all sides with the value of the left side.

Change the unit in the Unit combo box.