PowerEsim, a free (SMPS) switch mode power supply and Transformer Design software, Simulation, Calculation Tool

www.PowerEsim.com

What is Power Supply/Power converter?

Supply of power electrical power is called a power supply. Electric energy is transformed to be the engine of any power supply. This kind of electronic system converts electric energy to mechanical energy from the source to a given load. In this case the device is more accurate to be referred as a "power converter" than a power supply.

What is design of Power Supply?

Design of Power supply is a sophiscated activity involving knowledge in different discipline. power electronics engineer need to design power supply day to day. To support and simplify their job, PowerEsim is here to be used as a virtual lab or virtual branch so that steps in SMPS design: the selection of component; building of transformer; thermal simulation; power loss estimation; waveform chart recording; failure rate calculation; PPM estimation are done in one click. There are free online resources about industrial and theoretical issues about all aspect of design of switching power supply. It also includes many smps and power electronics circuit, schematics, topologies, theory of operation, application note, circuit analysis, on line educational course material.

What is Transformer?

A transformer is a device that transfers electrical energy through it's coils (an inductively coupled conductors). Varying current through the first or primary winding creates a varying magnetic flux in the transformer's core, and thus a varying magnetic field in the secondary winding, induces a varying electromotive force (EMF) or "voltage" in the secondary winding. This effect is called mutual induction.

What is Transformer Design? How to do Transformer Design?

Transformer design is a complex activity to construct a up-to-standard transformer. This including selecting different ferrite core, bobbin type, number of winding, winding method, etc. The designing process is targeting for a smaller, lower power loss, lower temperature and stable power output. Tranditional transformer design process include tedious replace and try process to find a suitable combination of core, wire and type. Thus the efficiency of transformer designing process depends on the experience of engineer. PowerEsim provide virtual branch to perform testing on combinations of different core and wire of different manufacturer. This speedy platform allow user to get result of each combination of transformer in seconds.

So what PowerEsim can do?

PowerEsim is a Switching-mode power supply circuit design tool, providing accurate simulation and integrated features:

Component loss analysis

Essential waveforms

Transformer winding design

Input harmonics analysis

Feedback loop analysis

Thermal analysis

MTBF prediction

Design Verification Test (DVT) report

Monte Carlo Analysis

More To Learn about PowerEsim

Introduction to PowerEsim
PowerEsim Help Manual:
PowerEsim - Introduction
PowerEsim - Requirement
PowerEsim - User Interface Practice
PowerEsim - Account Management
PowerEsim - Getting Start
PowerEsim - Project Management
PowerEsim Analysis Modules:
PowerEsim - Loss Analysis
PowerEsim - Waveform Analysis
PowerEsim - Loop Analysis
PowerEsim - Thermal Analysis
PowerEsim - MTBF Analysis
PowerEsim - BOM Builder
PowerEsim - DVT Analysis
PowerEsim - Magnetic Builder
PowerEsim - Add Part Module
PowerEsim - Smart Optimizer
PowerEsim - Magnetic Builder
PowerEsim - Save and Load Design
PowerEsim - Troubleshooting

Other resources

Guide and Resources page for Power Electronics

How to start?

Go to www.PowerEsim.com and get started. It is a free on-line tool!
PowerEsim, a free (SMPS) switch mode power supply design software and Transformer Simulation,Calculation Tool